To resync your Wireless Remote Controller or sync a new remote with your Transformer 15K or Carrier 13K, follow this simple procedure:
- Start with the remote off/in sleep mode. It will be required for later steps.
- Pull the Red Battery Disconnect Switch on the module to the out position to connect your batteries to the circuit.
- Push and hold the dolly’s silver on/off button for 15 seconds. The blue LED will turn on after about 1-2 seconds. Continue to hold the button until the LED starts to flash. The wireless receiver is now in "sync" mode, and waiting to receive a signal from the transmitter.
- Push the LOW button on the remote to wake it up. The red LED will illuminate on the remote.
- Press any directional button on the remote. The blue LED will stop flashing, and the motor should now operate on the dolly to match the directional controls.
That's it! Your dolly should now be operating as normal.
Questions about connecting a remote to your dolly? Contact us
April 9, 2025